Able to log from Innovate Motorsports 2.

Here are the tips on installing and configuring Vediamo with OpenPort 2.0 + trendy Agility mode.

Able to apply GND or 5V-25V to OBD pins 1,3,9,11,12,13 or AUX 2.5mm stereo connector You cannot use Vediamo 5 with Tactrix openport 2.0 because 5 does not support passthru so you need to install Vediamo 4 with openport (Check Openport Xentry Pros & Cons ).

Standalone datalogs to microSD / microSDHC card without a laptop.

J2534 PassThru support with Windows DLL.

USB 2.0 full speed device (USB-A/Mini cable included).

Choose the adapter you need from the 'Reflash Adapters' drop down list on the right side of this page. For Mitsubishi, you'll need the adapter for most pre CAN vehicles which include the 5-9 Evo. No other Subaru vehicles require reflash adapters including Forester, Baja, Legacy, or naturally aspirated Impreza models. For Subaru you'll only need a reflash adapter for the 2001 through 2005 WRX, but not STi, unless you're working on an early non USDM STi in which case you made need one of our WRX adapters. We include a USB cable with each OpenPort, which is all the hardware you'll need unless you have one of the few vehicles that require a separate reflash adapter. Combined with our EcuFlash software, the OpenPort 2.0 is capable of reflashing a large number of newer Subaru and Mitsubishi vehicles, and support for other cars is in progress. It repeats those last lines constantly until I kill the app.Īlso, if I try skipping the test and instead attempt to open any of the Control Units on the main window of the app, it gives me the error Couldn't open the diagnostic interface! Maybe the device is already in use by another application.The OpenPort 2.0 is our newest tuning tool hardware that is capable of communicating with most OBDII compliant vehicles using a standard J2534 interface. (I tried it twice for good measure, after unplugging the OpenPort and plugging it back in) It got to that point within seconds of hitting the Test Diagnostic Interface button, and then didn't produce any more output until I killed the app. PassThruReadMsgs(): received J2534-message with protocol id 0x3, rx status 0x0, extra data index 7: PassThruReadMsgs(): received J2534-message with protocol id 0x3, rx status 0x1, extra data index 10: => message indicates that an incoming message transfer has commenced. PassThruReadMsgs(): received J2534-message with protocol id 0x3, rx status 0x2, extra data index 0:

SSMP2communication_core::SndRcvMessage(.): sending message: SSMP2communication::run(): operation: readMulti Libpng warning: iCCP: known incorrect sRGB profile Parsing J2534 library definitions XML data. Trying to load J2534 library definitions XML file: './definitions/J2534libs.xml' QStandardPaths: XDG_RUNTIME_DIR not set, defaulting to '/tmp/runtime-root'